Specifications:
Module type: MC-DY603
High voltage type: pulse direct current split type
Input voltage: 3.7V-7.4V
Input current: 1-2A
Output voltage: about 800KV
(please pay attention to safety when using!)
Output current: about 1A
High voltage bipolar discharge distance: 2-4 cm
Discharge time: about 50s (no more than 1 minutes)
Size: 13.5 x 2.2 cm
About input power:
You can use a single 3.7V lithium battery or two series, such as 18650, idle cell phone batteries (need to remove the protection board, the proposed capacity is 2000mAh or more) or NiCd / NiMH battery pack, 4V or 6V lead acid batteries (6V batteries can achieve the best results)
Attention:
1. High voltage module should avoid the use of high voltage no-load, you must adjust the appropriate distance between the front end of the high-voltage electricity, high-voltage arcing distance is proportional to the voltage and capacity of the batteries used.
2. To test arc distance from short to long experiment, the power is strictly prohibited exceed the maximum arcing distance, if the energy can not be released due to high pressure, can easily damaged modules.
3. Because of the high power of module, the internal cooling slowly, so it can not work long hours.
4. Determine whether the battery capacity can drive a maximum power output is to measuring the arc battery voltage. If about 6V can output maximum power.
5. Two small-capacity lithium series is 7.2V, measured arc voltage state has fallen to about 4V, the smaller capacity the smaller voltage. It is recommended to use lithium 2000MA above, the best conditions with 4000MA above batteries.
Note:
1. The size of the input voltage will affect the output voltage and arc distance.
2. Note that this is not a high temperature arc, not cigarette paper
3. Please use the methods and precautions to operate in strict accordance with the operating module, otherwise it is easy to damage the module.
Package included:
1 x High voltage generator
