Technical Parameters:
Product Name: Modified sine wave inverter change pure sine wave rear plate
Input voltage: DC380V.
Input voltage: AC16V.
Output voltage: AC220V.
Output frequency: 50 / 60HZ (adjustable)
Output waveform: pure sine wave.
PCB Specifications: 165X100X50MM.
2000W using power tube: 4 / 47N60
Instructions:
Product are modified wave inverter charge sine wave inverter, can make modified wave inverter 2000W, etc …,
as modified pure sine wave inverter.First, remove the power tube after correction inverter, and then look at the
correction inverter have how many transformers , look at the transformer secondary circuit is
connected in parallel or in series, and then add the transformer parameters, modified wave
transformer secondary is parallel , In each transformer secondary plus 16 laps.
The secondary of the modified transformer is a series type, plus 8 laps per transformer
secondary. Then in the correction transformer which transformer one empty foot plus a small
voltage parameter, the small voltage parameters using 0.6 copper wire, in the transformer
inside around: 5 laps, the small voltage is linked AC: 16V position. (Note: Do not open the magnetic ring
when the add transformer with the parameters) After the addition of transformer
parameters, we must correct the modified wave inverter high voltage capacitors in exchange
for 220UF / 450V, Remember: modified wave inverter high-voltage capacitor has a
positive feedback Resistance, the resistance is a few hundred K, but also need to change a large
resistance, or the voltage will not rise. After testing the voltage of high-voltage capacitor (positive/negative) voltage is DC380V,
the test voltage is normal, the use of cable to the sine wave after the board, after the board output voltage: AC220V / 50HZ,
the output waveform: pure sine wave.
Package included:
1 x DIY 2000W Pure Sine Wave Inverter Rear Plate Kit
